
soldering part 1
-
- Posts: 1460
- Joined: Fri Jul 13, 2007 1:10 am
- Location: Port Macquarie Australia
- Been liked: 525 times
- Contact:
soldering part 1
I will keep this simple . This is what I use . Blow torch pen type , Yorkshire flux, rosin core solder , small clamps , file , wet and dry sand paper , KS brass .


-
- Posts: 1460
- Joined: Fri Jul 13, 2007 1:10 am
- Location: Port Macquarie Australia
- Been liked: 525 times
- Contact:
-
- Posts: 1460
- Joined: Fri Jul 13, 2007 1:10 am
- Location: Port Macquarie Australia
- Been liked: 525 times
- Contact:
-
- Posts: 1460
- Joined: Fri Jul 13, 2007 1:10 am
- Location: Port Macquarie Australia
- Been liked: 525 times
- Contact:
-
- Posts: 1460
- Joined: Fri Jul 13, 2007 1:10 am
- Location: Port Macquarie Australia
- Been liked: 525 times
- Contact:
-
- Posts: 1460
- Joined: Fri Jul 13, 2007 1:10 am
- Location: Port Macquarie Australia
- Been liked: 525 times
- Contact:
Hi Dale,
I been looking at torchs and gas plus supples for solding.Mosty learning about what I need.I pick up a small torch,but it's too small,and I saw a better 1 from Mirco-Mark.And ace has 1/8 brass angle 3' long.I havn't seen any 1/2 round brass for the panther mug guards.There's a big supply house
1 hr drive from me.
And I found out the solder comes in many different forms.60/40 or 40/60
and 50/50 req. bar.resin core & acid core.I acid core is what I have now,used for electricity.Whats in the 60/40?
Have a nice day. Dan
I been looking at torchs and gas plus supples for solding.Mosty learning about what I need.I pick up a small torch,but it's too small,and I saw a better 1 from Mirco-Mark.And ace has 1/8 brass angle 3' long.I havn't seen any 1/2 round brass for the panther mug guards.There's a big supply house
1 hr drive from me.
And I found out the solder comes in many different forms.60/40 or 40/60
and 50/50 req. bar.resin core & acid core.I acid core is what I have now,used for electricity.Whats in the 60/40?
Have a nice day. Dan