Cheers in advance
Rivet tool
-
Manny Leung
- Posts: 90
- Joined: Sun Mar 03, 2019 11:26 pm
- Has liked: 2 times
- Been liked: 83 times
Rivet tool
I'm about to rivet the 1mm rivets to the bin lids,could anyone recommends a riveting tool to do the job? All of the rivet gun's minimum rivet size is 3mm.
Cheers in advance
Cheers in advance
-
Steve Lewington
- Posts: 338
- Joined: Tue Aug 26, 2008 7:46 pm
- Location: Aberdeenshire
- Has liked: 8465 times
- Been liked: 277 times
Re: Rivet tool
Hi Manny
Try rivet snaps buy two that are a suitable size for the rivets you are using.
The best place to buy then is E-BAY
Hope this is of help to you.
Steve
Try rivet snaps buy two that are a suitable size for the rivets you are using.
The best place to buy then is E-BAY
Hope this is of help to you.
Steve
There is no time for peace.
No respite.
No forgiveness.
There is only ......WAR.
SdKfz 7 Half Track, 88mm Flak 36, Panzer III, TIGER I Mid 2010, Panzer iv, Sdkfz251, Famo ,Chech Hedgehog x2
Ammo limber, 25 pounder, Baily Bridge.
No respite.
No forgiveness.
There is only ......WAR.
SdKfz 7 Half Track, 88mm Flak 36, Panzer III, TIGER I Mid 2010, Panzer iv, Sdkfz251, Famo ,Chech Hedgehog x2
Ammo limber, 25 pounder, Baily Bridge.
-
Adrian Harris
- Posts: 5052
- Joined: Thu Jul 12, 2007 10:46 pm
- Location: Berkshire (UK)
- Has liked: 1363 times
- Been liked: 1557 times
Re: Rivet tool
3/64" is 1.2mm, so might be OK.
Ebay item 330703010063
Adrian.
Ebay item 330703010063
Adrian.
Contact me at sales@armortekaddict.uk for details of my smoker fan control module
-
Manny Leung
- Posts: 90
- Joined: Sun Mar 03, 2019 11:26 pm
- Has liked: 2 times
- Been liked: 83 times
-
Armortek
- Site Admin
- Posts: 2876
- Joined: Tue Jul 10, 2007 10:30 am
- Location: Winchester, England
- Been liked: 3379 times
Re: Rivet tool
May be stating the obvious, but the rivets do not need to be "riveted" . A dab of industrial strength glue and some pliers to snip the protruding part internally would do the trick as well.
Armortek
-
Dennis Jones
- Posts: 889
- Joined: Wed Feb 04, 2009 11:19 am
- Location: Poole, Dorset
- Has liked: 10 times
- Been liked: 221 times
Re: Rivet tool
What's wrong with a hammer and dolly. I did all the rivets on my 251 that way.
Dennis.
Dennis.