Steves Elefant build

[simon_manning]

looks superb steve, they are a very impressive vehicle when complete, a nice job, regards simon.

[Steve Norris]

Basic camofauge has now been added to the fist Elefant

Little brother acting as a pattern above

Regards
Steve

[Ray Brown]

looking good steve.

[vincent hung shu yue]

Hi Steve
Really good looking!
Vincent

[Chang]

Hi Steve,

Two filler caps on the engine deck looks as the genuine parts.

[Steve Norris]

Hi Chang
These are modified Armorpax items, they do not come with the kit.
Regards
Steve

[Steve Norris]

Almost there.
The first of 2 Elefant builds is now nearing the end, electrics all sorted and just the final bits and pieces to complete.
Must say I do like the twin engine start sound supplied with the sound module.

Almost ready for its new owner

Regards

Steve

[nikolas george]

Mate, that looks sooo good. You can also have a father and son picture like the one Armortek took at the tank museum recently .
Or maybe take yours to the tank museum and you can have grandfather, father and son !!
Have you got it running yet ?
Nik

[Steve Norris]

Hi Nik
The Elefant is a big impressive kit and will look great when running. I have tested the electrics in this one and everything works fine including the drive motors I just have not run it on the ground yet.
Regards
Steve

[Robert E Morey]

Steve
Any finished pictures of the Elephants? Perhaps outside? I always enjoy your finished outside images.
Bob

[Steve Norris]

Hi Robert
Unfortunately I did not get chance to get any shots outside as the weather was very bad and I needed to get both tanks to the packers.

This is about the best shot of one of the almost complete Elefants

And packed in a custom made case for shipping

Regards
Steve

[Robert E Morey]

Lucky customers to have your beautiful work! They look great!
B

[Dave Jones]

Steve, hope you don't mind but I'm looking for a bit of advice.

I have just finished building the lower hull, all looks good except I have a gap between CR102 Upper Front plate and CR104 Hull Plate (see photo). Did you encounter this or have I simply run out of talent and got something upside down or back to front?

Appreciate your thoughts.

Thanks.

Dave

Lower Hull.jpg (81.88 KiB) Viewed 6095 times

[Chang]

Hi Dave,
I think this gap is there for every builder. Mine has got it. I simply fill it with car filler. Photos will be shown later.

Regards,
Lerh Chang

[Dave Jones]

Hi Chang

Thanks for the feedback. Out with the Milliput it is then. I'll fill the gap when I do the weld detail. I just wanted to make sure I hadn't done anything daft before I moved on too far.

Cheers!

Dave.