2016 Armortek audio system speaker question

[John Grima]

While working on two tigers (an 2004, and 2016 early) Both of these models are using the current 2016 audio / electric motion package. I see on the module that there are only outputs for one speaker. Is this system designed for one speaker, or are the two speakers patched into the same output?

I.E. Red to Red, Black to Black?

[yves mouton]

Hello John,

the wires for the speakers are two pairs of yellow and green ( for both speakers )
Regards Yves

[Phil Woollard]

Hi John , you will need to wire two of the Armortek/Tanoy speakers (or similar ohms value) in series using the single twisted pair, observe the polarity regards Phil

[Adrian Harris]

Both the Benedini and the amplifier are mono, so only one set of speaker connections.

You can wire two in parallel but watch the overall impedance.

Adrian

[John Grima]

Thanks guys, was a great help

[yves mouton]

Hello,

Hi John, i just see that the new Armortek sound module have only
two wires for the speakers, one green and one yellow ( older module have 2 pairs of wires ).

Adrian: so you have to connect the yellow and green wire to one of the speakers?
And put a separate wire between the two speakers ( connect - to - and + to + )
is that correct?

Is that also correct that there are only 2 modules now in the option packs?
I have only the sound and motion mudule.

Regards Yves

[Adrian Harris]

> Adrian: so you have to connect the yellow and green wire to one of the speakers?

Yes

> And put a separate wire between the two speakers ( connect - to - and + to + )
is that correct?

Yes

> Is that also correct that there are only 2 modules now in the option packs?

Yes

Adrian.

[yves mouton]

Hello,

Thanks to confirm this Adrian.
regards Yves