Churchill Mk3 number 67

[Phil Woollard]

Look very convincing regards Phil

[Adrian Harris]

I've got a Welbike kit on it's way, but it's literally on a slow boat from China. I ordered it in July

That exhaust system looks fabulous

Adrian.

[Gary Richardson]

I've got a Welbike kit on it's way, but it's literally on a slow boat from China. I ordered it in July

That exhaust system looks fabulous

Adrian.

Hi Adrian

Let me know when you get the Welbike as there are a couple of problems to avoid and parts not shown on the diagram.

Regards
Gary.

[Gary Richardson]

Hi all

I have added the brackets and 90 degree fittings to the exhaust boxes. These will support the shield plus the shield will have two support posts that appear to go directly to the deck. A bit more research is required to confirm this.

Regards
Gary

[Gary Richardson]

Hi all

A bit more progress this afternoon, I added the weld details on the exhaust box supports and connected the quick release fittings to the smoker tubes. The tubes needed heating with my hot air gun to get them into the right location but it means I only have to undo the six deck screws and four retaining nuts to remove the mid deck complete with all the exhaust system still attached.

Regards
Gary

Quick release exhaust connection

[Gary Richardson]

Good morning all

I couldn't resist doing some weathering on the exhaust system, still some way to go but here is the initial result.

Regards
Gary

[Steve Lewington]

Hi Gary
Fantastic job you're doing mate.
Kind regards

Steve

[Gary Richardson]

Hi all

I found another little job I had forgotten to do, namely the stud guards on the applique armour fixing points. I used 11/32" brass tube with M4 brass nuts soldered in place. I decided to leave a few off as photos often show some missing.

Regards
Gary

[Steve McEvoy]

Great detailing mate.

[Vince Cutajar]

You are really going all the way with the detailing. Keep it up.

Vince