Broken steering wheel

[Andy Thompson]

Anyone else broken the spokes in the steering wheel yet?!
They aren’t really strong enough if a driver is going to be used.
Any tips on alternatives? I’m thinking maybe thin brass rod.

[Bob Mitchell]

Mine broke as well. For now I superglued the detached spokes back and resprayed the wheel….it’s ok for now. I have looked for another wheel but not yet found one but I will keep searching! Good luck!
Bob Mitchell

[mick whittingham]

I made a new wheel before the inevitable breaking of the plastic one.
Plus the one I made is the correct one for HUE.

20240419_163832.jpg (236.82 KiB) Viewed 706 times

[chris fry]

Hello,
If you follow the tip in the instructions that will strengthen the ribs on the steering wheel,

11.jpg (110.02 KiB) Viewed 678 times

Hope this helps,
Chris.

[Andy Thompson]

I made a new wheel before the inevitable breaking of the plastic one.
Plus the one I made is the correct one for HUE.

20240419_163832.jpg

Nice job

[Philip Capel]

As already mentioned in a previous post Armortek could have supplied something better!! 3D printing is not the best production methode for this kind of parts. I have a 1/6th Chinese produced radio controlled Jeep with injection molded parts which has better strength steering wheel. I understand that this cannot be done for small serie production but using 3D printing is an easy way out. I think paying the price we have done for a none intended static model Armortek could supply us a better replacement part for this as i think it is a production and design failure.

[mick whittingham]

The replacement steering wheel that I made took a long time to produce.

I'm not sure how Armortek would be able to come up with a stronger wheel for a limited production run such as the 4x4 car.

I can understand people's frustration that such a visible part seems to be insufficient for a working model.

But it is what it is and I don't think it can be suitably addressed by an upgraded part.

Just my two penneth.

Mick