Page 1 of 1
does any one know ?
Posted: Wed Oct 15, 2008 2:44 pm
by Derek Attree
Hi Guys
For the fighting compartment of a stug III I need to know the plate thickness
around the fighting compartment.at this stage I am interested in the thickness of the side walls and the rear plate , front plates and roof.
As I would like to make these to go on my PZ III
Thanks
Derek
Posted: Wed Oct 15, 2008 4:56 pm
by Dave Dibb (Armorpax)
Hi Derek,
If your building the late one as we discussed 30mm sides and rear, 50mm front excluding any add on armour and between 10mm and 16mm roof depending on which piece,
Cheers
Dave
Posted: Wed Oct 15, 2008 5:55 pm
by Adrian Harris
Derek, which Stug are you going to be building
I've been toying with the idea of an early model - no need for a cast mantlet
but probably a whole raft of chassis changes required
Adrian.
Posted: Thu Oct 16, 2008 8:15 am
by Derek Attree
Hi Dave
That's great info thanks just what I needed.
Did you get my email the other day? I used you other address not the armorpax one.
Adrian
I am thinking of the late one.so running gear should be the same
I would like the fighting compartments interchangeable.
The only other thing that is different is the front inspection hatches.
Derek
Posted: Thu Oct 16, 2008 10:16 am
by Dave Dibb (Armorpax)
Hi Derek,
Yes got it, but been a little pre-occupied
Will get back to you in the next day or so,
Cheers,
Dave
Posted: Thu Oct 16, 2008 10:26 am
by Derek Attree
Dave
That's Fine.
Derek