Page 1 of 1
Exhaust armour lifting lug
Posted: Sat Feb 19, 2022 3:51 pm
by Søren Sandvold
Hi all.
I'm about to make some lifting lugs for the exhaust armour shields. Does anyone know the correct dimensions?
TIA
Re: Exhaust armour lifting lug
Posted: Mon Feb 21, 2022 10:01 pm
by Søren Sandvold
Just a follow-up on what I did regarding the lift lugs.
Turned the lugs in brass on a lathe.
Dimensions i used was:
The shaft: 5x12mm
The endknob: diam 8mm 2.5mm thick.
I drilled a 5mm, 11mm deep hole and adjusted the lenght of the complete lug to protrude 7.5mm from the casting. I glued mine in with slowcuring CA.
Correct placement and depth of the lug should be determined by your heatshild cutouts.
Re: Exhaust armour lifting lug
Posted: Tue Feb 22, 2022 6:34 am
by Robert Kovacs
Yesterday I started looking for information about the lifting lug
Thanks for the post
Roberto