Armortek

The subject has been touched at another place in the forum, but I think a discussion on 3D printing belongs in this category.
Here is a comparison between different pieces of slicing software:
https://www.youtube.com/watch?v=USA29CuYOvk#t=839.801
From there, you will find links to other videos on the subject.

I am using Slic3r, but have never managed to get supports working satisfactorily. I will try to reduce the distance as suggested, but suspect they will be still harder to remove...

Cheers,
/Chris

Interesting review and note he came to the same conclusions that I did in the followup vid.. Simplfy3D was the best but then that's not surprising as it is paid for software.

John