CHALLENGER 2 PRE-ORDERS
NOW OPEN
EMAIL US AT SALES@ARMORTEK.CO.UK TO PRE-ORDER
CLICK HERE FOR MORE DETAILS


3D printing

Forum for Armortek Owners to Meet, chat and share knowledge. You are advised to check 'official advice' before carrying out any modifications.
Post Reply
Christoffer Ahlfors
Posts: 695
Joined: Sun Feb 14, 2010 5:19 pm
Location: Stockholm, Sweden
Has liked: 732 times
Been liked: 333 times

3D printing

Post by Christoffer Ahlfors »

The subject has been touched at another place in the forum, but I think a discussion on 3D printing belongs in this category.
Here is a comparison between different pieces of slicing software:
https://www.youtube.com/watch?v=USA29CuYOvk#t=839.801
From there, you will find links to other videos on the subject.

I am using Slic3r, but have never managed to get supports working satisfactorily. I will try to reduce the distance as suggested, but suspect they will be still harder to remove... :roll:

Cheers,
/Chris
A little too much is about right...
Top
John Heath
Posts: 166
Joined: Tue Jul 07, 2015 6:23 pm
Has liked: 4 times
Been liked: 102 times

Re: 3D printing

Post by John Heath »

Interesting review and note he came to the same conclusions that I did in the followup vid.. Simplfy3D was the best but then that's not surprising as it is paid for software.

John
Top
Post Reply

Return to “Armortek Owners”