Armortek

Hi all,

I have assembled the first of my horstmann bogeys on the centurion and wonder if I have an issue?

When the unit is assembled the spring assembly does not contact the suspension arm fingers but sits free betwwen them under no compression. Have I slipped up or does the compression come on when the weight of the tank is on them? The instructions seem to suggest the spring should be compressed a little to facilitate fitting the bump stops.

Any suggestions please.

Regards Mick.

Hello Mick

You should find, that if undo the stud cap (EH0212) a couple of turns, the arms will be sitting against the stop blocks (EH0208)_ and there will be a little tension on the spring.

Mark