The Official Armortek Forum - World leader in one sixth scale metal kits

Am looking to buy a zimmerit application tool for Armortek Tiger 1 asap.Please email me at rcom1990@yahoo.com if you want to sell yours. Thanks

Hello Ramon

Just use a piece of metal bar 20mm across.

Lee

I just used a paintscraper tool as it already had a comfortable handle. Cut the blade. I think i went with about 22 mm blade width. If you use milliput it works realy well. Takes a lot of zimmerit. Use a rolling pin and roll out milliput to about 1/16 inch and work into the plates. Have a good bulk supplier of milliput on ebay.
Time consuming but enjoyable.

Thanks very much folks....I am off to zimmermit land.