List of other potential parts to be made.
Posted: Fri Oct 30, 2009 7:23 pm
Hi Guys
I decided to condense all other potential parts to be made into one post. I have not made prototypes of these parts and most have not been researched, so no estimated prices.
Parts for Tiger 2.
1. Engine Grill Covers, all types. (Photo-etched brass and copper mesh)
2. Engine Grill Cover Step Plates. (Photo-etched brass or cut aluminum)
3. Drivers Rotating Periscope. (Cast white metal)
4. Loaders Hatch (Cast white metal)
5. Spare Antenna Stowage Tube. (Photo-etch brass and tubing)
6. Engine access hatch hinges and lock bars. (Cast white metal)
7. Jack block with wing nut fitting. (Wood, photo-etch brass and working wing nut)
Tiger 1
8. Smoke and Grenade Dischargers (All metal)
Panther
9. Drivers Rotating Periscope. (Cast white metal)
Other parts used on several types of tanks.
1. Working Jacks (15-20 ton) based on Roland Mann design with permission. (All metal)
2. Armored Hinges (Panther and Panzer III) (Cast white metal)
3. 88 mm three round wicker carrier. (Resin and photo-etched brass) I now have all detail to produce this correctly.
Once again send me a list of your interest, plus any other parts you would like made.
Regards
Mike
I decided to condense all other potential parts to be made into one post. I have not made prototypes of these parts and most have not been researched, so no estimated prices.
Parts for Tiger 2.
1. Engine Grill Covers, all types. (Photo-etched brass and copper mesh)
2. Engine Grill Cover Step Plates. (Photo-etched brass or cut aluminum)
3. Drivers Rotating Periscope. (Cast white metal)
4. Loaders Hatch (Cast white metal)
5. Spare Antenna Stowage Tube. (Photo-etch brass and tubing)
6. Engine access hatch hinges and lock bars. (Cast white metal)
7. Jack block with wing nut fitting. (Wood, photo-etch brass and working wing nut)
Tiger 1
8. Smoke and Grenade Dischargers (All metal)
Panther
9. Drivers Rotating Periscope. (Cast white metal)
Other parts used on several types of tanks.
1. Working Jacks (15-20 ton) based on Roland Mann design with permission. (All metal)
2. Armored Hinges (Panther and Panzer III) (Cast white metal)
3. 88 mm three round wicker carrier. (Resin and photo-etched brass) I now have all detail to produce this correctly.
Once again send me a list of your interest, plus any other parts you would like made.
Regards
Mike