Armortek

Hello,

now I have available my track-links. I can offer You the following:

-Track-set, 115left/115right (96 + spares per side), shim-set steel to add on pins, shim-set brass to adjust link-gap, pin-rod-lenghts from hard-brass to make pins and a 4,1mm long-drill to hone-out the holes.


for 2380Euro + shipping.


Please allow 6 weeks for selection/packing/shipping.

The tracks are from heavy-duty steel/investment-casting, 100% accourate in every detail, exact 3D-copy from original item with minor adjusting to match the Amorteks Kingtiger geometry (please note: The amortek-Sproket-rings are not usable / does not match in diameter). The links come finished and sand-blasted, just to have a little drill-out with 4,1mm of the casted pin-hole to remove some stain and roughness.
Do not hesitate to ask me any question You may have and send me an email and I return You some pictures asap.

Email me to: op@piekenbrink.de


With kind regards, Olaf

Hi Olaf,
Is the 18-teeth sprocket ring the next project?
Thanks!
Lerh Chang

Chang wrote:Hi Olaf,
Is the 18-teeth sprocket ring the next project?
Thanks!
Lerh Chang

Hello Lerh,

many thanks for your message.

Yes, I work on the dimensional geometry/doing 3D-drawing at the moment. No idea if I make sets of rings and sell them or provide/sell the 3D-datas, only.

with kind regards , Olaf

Hi all,

Here are some more photos of Olafs links:










Cheers
Kent

Those are a work of art. Amazing! Interesting how they are hollowed out to reduce weight apparently.

Those tracks should never wear out!
Bob