The Official Armortek Forum - World leader in one sixth scale metal kits

can anyone show with a picture the way to hook up the headlight and tail light on panther to the r/c switcher unit. power in and light circut

Hi Mark

I used a simple RC switch. It comes with RC type plug and plugs into the receiver. It is then wired to the power source(in my case a 9 volt battery) and the two lights (front and rear convoy lights). Pick a channel on your Radio unit with a simple two-way switch and you are done.

Here's the one I used and where I purchased it. They are a great source for lots of cool stuff.

http://www.robotmarketplace.com/product ... TLSW1.html

If I get a chance to pull the turret and deck from my Panther I'll take a photo.

Kind regards
Tim

Hello Mark

I just use an extra switch unit supplied by Armortek. Simples.
Electrlize one.

Lee

lee can you show me how you wired it

Hello Mark

You need a seperate switch unit. Terminals used are NO and RLA or RLD.
I use a small 3.2Ahr battery and put a fuse in and the + onto RLA off on NO and then onto the feed to the convoy and headlight. - back to the - on the battery.

Lee