The Official Armortek Forum - World leader in one sixth scale metal kits

this is one of the little jobs, that you think will only take about 1/2 an hour; the linkage is on both sides of the 222, and situated below the doors, to have it functional the main lever has to have "V" shaped ends holding the pivot pin, and this is drilled and tapped to take the push rods, about 3 hours work and one more job out of the way


regards
Jeff

Splendid detail again, where did you get the small cable and bellows?

You can come around my place and help remove the old aircon system from my Mustang. Its been very unreliable and you can't easily get the old gas now thanks to the greenies. I can then fit a bigger radiator to keep the engine cool in the ubiquitous traffic jams!!

Hi Allan, I think I will stick with 1/6th scale, I have not played inside an engine compartment for years,

the cable and bellows I made.

have you sorted out the Sherman yet
regards Jeff