Armortek

Phil is right.
a) The secound position I did
b) don't cut the shaft nut.
You will see the hole on the top of the case over the shaft nut. I set the shaft nut in the rigt way (like I wrote it allready). Than make the hole about 3mm deeper in the brass, fixing the shaft nut with loctite, and install the pin as in the manual, also with loctite. so you have the right position for the shaft nut fixed.

Hi Florian, looking back through your thread and looking at your drive sprockets, have you bonded the rubber to the sprockets in that position ?

Hello @ all,
after the x-Mass break, I'll continue my report. Made some details finish for the fame

The special fasteners for the track chain, coming soon in end of March. so this one who want a set, and did'nt order it. Please PM.
I have a previos set...

Nice details added florian

Very nice bonnet vents Florian.

Thanks for the feedback. Its easyer to work on it, if you know that somebody appreciates it.

Some more details. Now Iam on the window frame and the exhaust pipes.
Sorry for the bad photo quality, but you can see the rivets I have set and the new position for the handrail.

I'm back, making some more details on may wind sheeld. Unfortunatly my window is broken while I install it in the frame. So I must built an new one in time...
I installed it provisionally, so not all fasteners are fixed, and I ahve'nt the wing-nut yet.

Its could outside, so I worked a bit on more function details. Making the winkers.

Very nice detail piece Florian

Thanks Phil. I Hope its a good effect in the end.

Yesterday I installed the mechanik for the winker and connect it with the winkers. So this work is completly done.

Looking good. Have you bonded the sprocket rubbers in that position Florian or are they loose?

Hi Phil,
they are loose in time. Why do you ask?
I made the rubber with dubble tape, because I don't know the realy right position now.