Armortek

Hi Martin
That is really well made I looked at the picture again closely and this time I could see the simulation ::D

Thanks Steen,
now it is time to make all the welds. The cone head bolts in front are replaced by new nuts M4 from Knupfer ( with small key-with ) and reduced the high to approx. 3mm, so it looks near to the origin. Also added some hex. screws on the roof plate.

After some emails and a little waiting i got the beautiful bump stops parts from Michal Matata.
At this place again: many thanks for this parts. This is a high light to every StuG or PanzerIII. Here are the first impressions.

Nice addition, I have ordered a set.

Cheers

Awesome details

Thanks Björn,
A bit more progress on the side walls.

Realy great build. Nice to watch this projct...

Thanks Florian,
here are a small update for the gratings of the air inlet, the brackets for the gun cleaning rods and the steel tow cable brackets.

After a long time here are the next steps for the covers on the bottom plate and the first mount of the side walls.

Stunning details!

A true master piece

Michaels detail parts really take the Stug III/PzIII to a new level. Really nice looking hull.
Best regards,
Bob

The work and detailing you put in this model is amazing, I’m impressed with your work. This model is going to be top notch

Hi Chris, Björn, Bob and Roy,
many thanks for your nice words, they are very welcome - sorry for not answer so long, but i am very busy at the moment.
Here is a very small update from the torsion bars and the fixed ends.

Realy nice build.
Another masterpice is growing up here.
Cheers
Florian