2025 ARMORTEK KIT SURVEY

Over the last few years we have brought out a whole series of kits as a direct result of your feedback - kits like the Pershing, JagdPanther, Hetzer, Leopard 2A4, and more recently the Sd Kfz 7, 88mm Flak 36 and the upcoming Challenger 2.

So, in keeping with what has become and annual tradition, here is your opportunity to once again influence our future production plans.

We have added in some "guide pricing" next to the names of the models. This is a rough estimate of the price at the current rates.

Thanks in advance for your input and we look forward to the results.

Taper Lock Bush question

Forum for Armortek Owners to Meet, chat and share knowledge. You are advised to check 'official advice' before carrying out any modifications.
Post Reply
Malcolm.Plumb
Posts: 242
Joined: Mon Oct 31, 2022 1:37 am
Location: Evesham, Worcestershire
Has liked: 451 times
Been liked: 912 times
Contact:
Contact Malcolm.Plumb

Taper Lock Bush question

Post by Malcolm.Plumb »

I'm making my first attempt at fitting the drive sprocket and taper lock bush.

Is it OK that the bush is not flush with the inner edge of the sprocket?
I started with it being flush but as per the photo it is now slightly lower as I have tightened the grub screws.

I have stopped so the screws are not fully tightened at this time.

Best make sure I think before tightening further. :|

Any help would be greatly appreciated.

Thanks
Attachments
IMG_6612.jpg
2022 Panther G #15
Top
Will Roberts
Posts: 58
Joined: Mon Jul 23, 2007 11:24 am
Location: Swindon
Has liked: 8 times
Been liked: 29 times

Re: Taper Lock Bush question

Post by Will Roberts »

Hi Malcolm,

Yes, the taper bush doesn't need to be flush. The main thing is that the sprocket it very tight and the correct distance from the hull side. Once you have driven the tank for some time just check the screw tightness again.

Regards,

Will.
Top
Malcolm.Plumb
Posts: 242
Joined: Mon Oct 31, 2022 1:37 am
Location: Evesham, Worcestershire
Has liked: 451 times
Been liked: 912 times
Contact:
Contact Malcolm.Plumb

Re: Taper Lock Bush question

Post by Malcolm.Plumb »

Thanks Will

That's good then :D

Sprocket is at the required 34mm so will get back out to the tank and go ahead and tighten it up.

Malc
2022 Panther G #15
Top
Post Reply

Return to “Armortek Owners”