ADHESIVE

Forum for Armortek Owners to Meet, chat and share knowledge. You are advised to check 'official advice' before carrying out any modifications.
Post Reply
Graham Ord
Posts: 249
Joined: Mon Jul 16, 2007 11:15 am
Location: BRIXHAM
Has liked: 4 times
Been liked: 16 times

ADHESIVE

Post by Graham Ord »

I am making a Panzer IV to the Armortek plans with a few alterations to the manufacturing methods. I now need some advice on the best type of adhesive for a permanent joint which is fairly slow setting. Does anyone have any suggestions? I have considered soldering,brazing,welding but have not got the equipment to produce the heat.
Graham
Top
Ad Wouterse
Posts: 292
Joined: Thu Jul 12, 2007 4:32 pm
Location: The Netherlands
Been liked: 2 times

Post by Ad Wouterse »

Hi Graham,

Based on many years of trial and error, I can recommend to use JB Weld for joining steel, aluminium, brass etc.The adhesive version takes a couple of hours to set.
Degrease the parts and use sandpaper to get a rough surface.
Cheers,
Ad
Top
Post Reply

Return to “Armortek Owners”