advise please on king tiger electrics

[Andy Robinson]

good morning to you all im looking for some trouble shooting advice for my electrics on my 2019 king tiger i am trying to bench test my motion pack i have the red version for king tiger so far i am useing a spectrum dx8 gen 2 with supplied receiver AR1080 the issue is im not getting any motin on the motors i have set up the basic set up for two motors as recommended in manual and i have tried a servo and this works in throttle port and rudder port on left hand stick up and down and left and right but no power /movement on motors any advice or suggestions would be great thanks in advance andy

[Mark Heaps]

Hi Andy
I work with electronics and am willing to assist. Also ex-REME, fixing electrics & electronics on tanks was my job.
Please post the pages from the manual. I will then tell you where I need photos of your set-up to help identify the fault.
Mark

[Andy Robinson]

hi mark that is very kind of you to want to assist me with my issue obviously i cant go into the moduals themselves to try to sort problem out because of warranty but just hoped some one with experiance of the same problem could advise thanks again andy

[Adrian Harris]

When you bound the transmitter and receiver, did it say it bound at 11ms or 22ms ?

Do you only have the Module A plugged into the receiver ?

I can't find a 1080 receiver - did you mean a 8010 ?

Adrian.

[Mark Heaps]

Hi Andy,
I am not suggesting you open the modules.
I just need a wiring diagram to see how things should be connected amd then work out how the system is supposed to operate.
I can then give pointers where to look.
Mark