measurements

[Ray Brown]

g'day all. are nuts, bolts and holes in metric or imperial? also what are the sizes and thread for holes and bolts as i need to tap some of them to get a flush fit.

cheers in advance.

[Nick Farrugia]

Hi Ray
All nuts and bolts in the kit are metric M2/M2.5/M3/M4/M5 and M6
Hope this helps.
regards nick

[Ray Brown]

what about tap & dye sizes. i need to get the thread further to get the axle flush.

[John Fitzsimons]

I got a set of metric taps and they are labeled m3,m4 ect. Mine had 2 seperate thread sizes but easy to check the correct tap using the gauge.

[leesellars]

Hello Ray

What you need is a good quality tap and die set. From m3 to m12. Over hear in the UK a good set is in the region of £180.00. There are cheaper sets but they tend to snap and you don't want that. Also you need a cutting compound.
Top tip from my brother is use WD40.

Lee