panzerwerk.com

Martin Diessel · Post by **Martin Diessel** » Mon Jan 31, 2011 11:25 am

Good morning. I found the page of panzerwerk.com. Before I start annother "order adventure" as I had with annother vendor, is better to ask first. Since the HP in not very informative:
Is this for 1/6 scale??
Looks like most is made of resine?
Is the shop trustfull?? Deliverytime??
Thanks for any help.
Martin

Brian Leach · Post by **Brian Leach** » Mon Jan 31, 2011 3:46 pm

Martin,

Going to this link can help with most questions like yours:

http://www.sixtharmygroup.com/forums/cooler/

Good Luck,
Brian

Paul Morris · Post by **Paul Morris** » Mon Jan 31, 2011 4:09 pm

Hello Martin.

I have purchased from Panzerwerk in the past amd never had any problems with them at all, the items are very well cast and the post is pretty quick.
Don't know what you are looking for but have you checked out Armorpax? all Daves stuff is excellent and well priced with a very friendly service.

Hope this helps Paul

Allan Webster · Post by **Allan Webster** » Mon Jan 31, 2011 4:21 pm

I have bought items from Panzerwerks. I trust the company completely. My transactions have been supplied promptly, without error and with friendly service. I have also been very happy with the quality and detailing of their products. Strongly recommended.
Like Paul, I also find Armorpax an excellent company to deal with, on the same grounds.

Robert E Morey · Post by **Robert E Morey** » Mon Jan 31, 2011 5:01 pm

Martin,
I can only echo what everyone else said. Panzerwerks is very reliable company. All parts are 1/6 and resin but quality is good to excellent in my oppinion. I have always experienced prompt delivery. Steve is good about posting a note if orders are delayed. Hope this helps you,
Bob

Martin Diessel · Post by **Martin Diessel** » Mon Jan 31, 2011 6:14 pm

Hi Gusys thanks for your answers. In the meantime I got reply from Steve at panzerwerk.com. As I understood he slows down his business. The items I look for is the 2cm Muzzle break and the 2cm Vehicle Magazine (oth for the SDKFZ 222) So far i know Armorpax don not have these.
Thanks for all and I will go on with panzerwerk.
Martin

colin fairweather · Post by **colin fairweather** » Mon Jan 31, 2011 7:53 pm

Hi Martin

Hope your build is going well

as every one says Steve is an a+ seller
Some of the parts I sent you are from him also you could cut down the mags I sent you I think their was a post on the sag forum about it

Happy building

Colin

colin fairweather · Post by **colin fairweather** » Mon Jan 31, 2011 7:53 pm

Martin Diessel · Post by **Martin Diessel** » Tue Feb 01, 2011 3:19 am

Hi Colin, yes I did cut the magazin alredy and have a good looking muzzle break from Dragon, but thse parts do look a lot better. Martin