Suspension. What Am I Doing Wrong?

[Armortek]

Hi Darryl

Use a long M4 screw from your fastener pack and screw into one of the grub screw holes and use this as a lever to tighten the shaft up further.

regards
Mark

[Darryl Vernon]

Hi Darryl

Use a long M4 screw from your fastener pack and screw into one of the grub screw holes and use this as a lever to tighten the shaft up further.

regards
Mark

Lovely stuff! Cheers Mark.

Just done it. Blimey, it wasn't easy. I couldn't do it by hand, even with the screws in.
What I had to do, was wrap a cloth around the shaft to protect it, and then use pliers to enable me to give it that last little 'nip' up.

Still, it's done the trick. Thanks again Mark.

Darryl

[David Da Costa]

I would try using an appropriate die and tap to ensure the threads are clean all the way down and then try again.

David