Phil's Bailey Bridge Build
Re: Phil's Bailey Bridge Build
I have made up some wooden Ribands from sapele off cuts to replace the steel ribands supplied in the kit. They need to be trimmed to length and drilled to allow the securing bolts to be installed. Huge thanks to Charles A.Stewart who emailed me a drawing of the original wooden ribands with dimensions.
- Steve Lewington
- Posts: 338
- Joined: Tue Aug 26, 2008 7:46 pm
- Location: Aberdeenshire
- Has liked: 8410 times
- Been liked: 277 times
Re: Phil's Bailey Bridge Build
Hi Phil
The bridge is looking great bud.
Thank you for sharing the riband sizes that will save me a lot of research.
Also abig thanks to Charles for putting it out there for us guys.
Tiny and I have not done much over the past cupel of weeks we're under orders to decorate the house i think there's more paint on Tiny than on the walls.
Best Regards
Tiny and Steve
The bridge is looking great bud.
Thank you for sharing the riband sizes that will save me a lot of research.
Also abig thanks to Charles for putting it out there for us guys.
Tiny and I have not done much over the past cupel of weeks we're under orders to decorate the house i think there's more paint on Tiny than on the walls.
Best Regards
Tiny and Steve
There is no time for peace.
No respite.
No forgiveness.
There is only ......WAR.
SdKfz 7 Half Track, 88mm Flak 36, Panzer III, TIGER I Mid 2010, Panzer iv, Sdkfz251, Famo ,Chech Hedgehog x2
Ammo limber, 25 pounder, Baily Bridge.
No respite.
No forgiveness.
There is only ......WAR.
SdKfz 7 Half Track, 88mm Flak 36, Panzer III, TIGER I Mid 2010, Panzer iv, Sdkfz251, Famo ,Chech Hedgehog x2
Ammo limber, 25 pounder, Baily Bridge.
Re: Phil's Bailey Bridge Build
I have made a little bit of progress over the last couple of days due to a slight lull in my restoration schedule. Once I get the ribands bolted down temporarily I can get the decking planks trimmed and then remove both for staining and weathering.
-
- Posts: 541
- Joined: Tue Sep 07, 2021 5:37 pm
- Location: Somerset
- Has liked: 717 times
- Been liked: 1651 times
Re: Phil's Bailey Bridge Build
Hi Phil
I am enjoying following your build. You are doing a great job with the ribands which add authenticity and I look forward to seeing the end result. My bridge build is on the back burner while I make some progress on the Churchill AVRE, I have also been distracted by a 17 pounder I recently acquired which is proving rather addictive
Regards
Gary
I am enjoying following your build. You are doing a great job with the ribands which add authenticity and I look forward to seeing the end result. My bridge build is on the back burner while I make some progress on the Churchill AVRE, I have also been distracted by a 17 pounder I recently acquired which is proving rather addictive
Regards
Gary
2021 Late Tiger 1 Abteilung 301 (Funklenk), 2022 Churchill Mk3 AVRE, 2x Czech Hedgehogs, 2024 Triple span Bailey Bridge, M26 Pershing, 17 Pounder.
Re: Phil's Bailey Bridge Build
This afternoon I found time to drill the planking for the riband retaining bolts rather than notching the corners as suggested in the AT instructions. It all went together without any issues. The M3 square washers were found on eBay.