Video call

[mark lawson]

I'm going to try very hard for this one.
Happy New Year all.

[mark lawson]

I'm going to try very hard for this one.
Happy New Year all.

[Dave Goodwin]

Can anyone drop me the link to the chat? PM is fine...

[Christoffer Ahlfors]

These are my models:

The T1 is a 2010 mid version that I have backdated (partially) to an early version.

It's currently 5C in the garage, so avoiding any work there...

/Christoffer

[Jerry Carducci]

I want to thank Christoffer, Dave and all the rest of you who joined; we had a very good session yesterday!

See you all in a month..

Jerry

[Jerry Carducci]

Reminder!

Next session will be next Saturday, February 4, 13:00 Eastern/ !0:00 Pacific (or 17:00 UTC if you prefer).

Be there or be square!

Jerry

[Adrian Harris]

Saturday is the 3rd over here

Adrian.

[Jerry Carducci]

Saturday is the 3rd over here

Adrian.

Ooopsie! Indeed it is here as well! Sleepy eyes and hands are the makings of mistakes; better with the keyboard than with
one of my model projects!

Allow me to try again!:

Next session will be next Saturday, February 3, 13:00 Eastern/ !0:00 Pacific (or 17:00 UTC if you prefer).

Be there or be square!

Jerry

[Jerry Carducci]

Greetings and felicitations!

Reminder!

Next Zoom session will be next Saturday, March 2, 13:00 Eastern/ !0:00 Pacific (or 18:00 UTC if you prefer).

Hope you all are able to attend... if you need the link drop me a note.

Jerry

[Christoffer Ahlfors]

We were discussing recoil systems today. I shot a couple of clips to show you the one in Per Sonnervik's JT. This is a scratch build, so differs from Armortek. The small RC aircraft cylinder only has a 5cm throw. It should be 2-3 times that, depending on whether the gun was cold or hot. Despite this, it does a fair job, I think. Still, I am going to get industrial cylinders and valves to get more schwung to it.




The contraption is controlled by an Arduino, which reads the RC gun control servo signal and controls the valve servo on "dead reckoning".
//

[Jerry Carducci]

Apologies for being late to post this, The next video session will be tomorrow 4/6 at 13:00 Eastern/ !0:00 Pacific/ 17:00 UTC. (it's PDT over here)

I may need to keep the session right at an hour as I may have to leave abruptly.

Jerry

[Jerry Carducci]

Next Saturday May 4 will be our next Zoom session, usual time!

Jerry

[Jerry Carducci]

This coming Saturday June 1 will be our next Zoom session, usual time!

Jerry

[Jerry Carducci]

The next Zoom call will be Saturday July 6th, usual time.

This will be the last call I schedule; if one of you would like to take over coordination please let me know else this call will be our last.

Thanks to all who have attended these over the last year! It has been a great time.

Jerry