Page 1 of 1
Taranis xd9) millisecond to percentage change?
Posted: Sat Jun 10, 2023 9:10 pm
by Mark Allen
I got my transmitter and the 80 something page manual. Im surprised how far I got. Inputs (basic), mixers and outputs ready for the model. Even managed a custom curve for the turret traverse.
However, nowhere can I find out how to change the units in the displays from milliseconds to %.
Anyone?
Re: Taranis xd9) millisecond to percentage change?
Posted: Sat Jun 10, 2023 9:38 pm
by Adrian Harris
Only display I can see in uS is on the Output page.
Adrian
Re: Taranis xd9) millisecond to percentage change?
Posted: Sat Jun 10, 2023 9:43 pm
by Mark Allen
Hello Adrian. "Channel Monitor" page, and "Outputs" are in Milliseconds on mine. I can live with it but would prefer percentages.
Re: Taranis xd9) millisecond to percentage change?
Posted: Sun Jun 11, 2023 9:53 pm
by Adrian Harris
Check under the firmware options to see if the ppmus option is enabled.
Adrian
Re: Taranis xd9) millisecond to percentage change?
Posted: Sun Jun 11, 2023 10:42 pm
by Mark Allen
Yes ppmus is listed.
Re: Taranis xd9) millisecond to percentage change?
Posted: Mon Jun 12, 2023 8:37 pm
by Adrian Harris
You need to reload the firmware without that option selected, then it should show 100% on the channel monitor at least. Mine isn't selected but still shows the uS reading in the top line of the Outputs screen.
Adrian.
Re: Taranis xd9) millisecond to percentage change?
Posted: Mon Jun 12, 2023 9:16 pm
by Mark Allen
Thank you Adrian. I guess that will require openTX companion? Unfortunately (for me) companion will require a new computer for me, was hoping to avoid that.