Page 1 of 1
CNC Machining Magazine
Posted: Thu Oct 16, 2008 8:49 pm
by Rich Stinchcomb
I'm not sure if this article has been discussed already, but check out the Summer 2008 issue of CNC Machining. Nice writeup on Armortek on pages 8-10.
Issue 41 Summer 2008 CNC Machining
Posted: Fri Oct 17, 2008 2:01 pm
by Phil Markham
Thanks Rich,
Heres a link to the PDF version of the magazine and article
http://www.haascnc.com/CNCMag/PDF/v12i41.pdf
Phil
Posted: Sat Oct 18, 2008 6:45 pm
by Robert E Morey
Rich, Phil
Thanks for posting this link. I always enjoy articles on CNC and tanks!
Richard, Congratulations on your recent addition - a baby daughter. I hope everyone in your family is doing well afterwards.
Bob
Posted: Sat Oct 18, 2008 7:00 pm
by Allan Richards
As said a good article. Finding machines at the right price that are reliable is very important. My father has a very worn Myford ML7 lathe and wanted it reconditioned, but Myford were not that interested and the price eventually quoted was more than some new lathes with better capabilities!!. He's buying a new lathe and giving me the Myford, so does anyone know of any firms other than Myford who recondition these lathes??