The Official Armortek Forum - World leader in one sixth scale metal kits

I wired up my late tiger tank and the only thing that works so far is the left and right tracks...the turret turn and elevation is not working. Does anyone have any suggestions..I looked at the wiring diagram and I cant figure it out 100% maybe some one has a better diagram? thanks for the help

Hi Michael,

One time when I reworked the wiring in my Panther, I forgot to reconnect the elevation limit switches and it took me awhile to figure out that they were necessary to complete the entire circuit. I think it only affected the elevation though.

Are the electronic switches working when you try traverse or elevation? You should hear a soft 'click' noise when you move your radio stick/switch. If no, check that your radio control stick and receiver to electronic switch is correct. If yes, check if power to motor plug is correct.

Just some thoughts. Good luck

Regards

Tim

broken wire on one of the connectors..all works now..

michael didonato wrote:I wired up my late tiger tank and the only thing that works so far is the left and right tracks...the turret turn and elevation is not working. Does anyone have any suggestions..I looked at the wiring diagram and I cant figure it out 100% maybe some one has a better diagram? thanks for the help

I Had the same problem with my tiger, Mark from Armortek send my a new wire diiagram

Thank you for this information.
I can now see that your turret sub loom has a problem

You should have

Switches
1 black
7 black

Switches
3 black
4 black

Elevation motor
2 black
8 green/yellow

Firing unit
5 black
6 black

If you can change these connections everything will work. If you can not, send the turret sub loom back to us for correction. We apologise for this problem in our wiring

Regards
Walter