Page 1 of 1
Motion controller transmitter
Posted: Thu Sep 09, 2021 6:36 pm
by Fernando Kuehnel
Controller A: Not sending a signal to main motors left or right; getting power to the module but no output 25V. I have a signal in the receiver when attached servos to empty slots but motors not responding to transmitter input. Is the controller bad?
Re: Motion controller transmitter
Posted: Thu Sep 09, 2021 10:23 pm
by Adrian Harris
> I have a signal in the receiver when attached servos to empty slots
Do you mean when you put a servo into the channels used by the motors it moves as expected ?
It may be a bad module or it may not be in the right configuration mode.
Adrian.
Re: Motion controller transmitter
Posted: Fri Sep 10, 2021 10:40 am
by yulun.chang
![Image]()
I have the same problem, usually when the left track and right track channels are connected to the audio module at the same time, this problem occurs. My solution is to connect only one channel (left or right) to "RC inputs 1" of the audio module. Keep "RC inputs 2" empty.
Re: Motion controller transmitter
Posted: Fri Sep 10, 2021 12:27 pm
by Adrian Harris
yulun.chang - something to try.
Does the tank drive correctly if you have all the RC inputs connected on the Audio Module as per the manual but the Output 3 to Recoil Module disconnected (I know the recoil won't work) ?
Adrian.
Re: Motion controller transmitter
Posted: Fri Sep 10, 2021 12:29 pm
by Adrian Harris
Fernando - have you tried it with just the Module A connected ?
Adrian.
Re: Motion controller transmitter
Posted: Fri Sep 10, 2021 5:24 pm
by Fernando Kuehnel
Adrian,
Thank you. You are right I needed to connect my audio system. It is working now. This is my first build... Also, Mixing on the radio. I'm using Spectrum 7Ch. I got it moving forward and backward; I got it going left with one side of the track going forward and the other back to turn. Any suggestions?
Thanks,
Re: Motion controller transmitter
Posted: Fri Sep 10, 2021 7:54 pm
by Adrian Harris
> I got it going left with one side of the track going forward and the other back to turn. Any suggestions?
Do you mean it goes in the wrong direction ? Stick to the left, tank goes right ?
If so, swap over the two leads in the receiver which go to Module A.
Adrian.
Re: Motion controller transmitter
Posted: Mon Sep 13, 2021 2:44 pm
by Fernando Kuehnel
Adrian Harris wrote: ↑Fri Sep 10, 2021 7:54 pm
> I got it going left with one side of the track going forward and the other back to turn. Any suggestions?
Do you mean it goes in the wrong direction ? Stick to the left, tank goes right ?
If so, swap over the two leads in the receiver which go to Module A.
Adrian.
Thanks, Adrian. will try it.