Armortek

Hi Guys

Another question from a newbie.

If you look at the attached photo you will see that I screwed down ER0125 and the girder bent because there is a gap between the girder and the plate.

Should I use a couple of washers/spaces and a bigger screw.

Many thanks

Bob

Bob it may be worth easing off the larger part as they bolt together to see if something is out of line. I checked on mine and I don't have such a 'step' on mine. Always better to see if you can adjust the parts before you alter the instructions.

Many thanks for your wise advice Graham as I have managed to force it up a bit.
all the best
Bob