Armortek

Hello to everyone
Received my first Armortek kit in June and have been busy
- setting up shop in basement of my house
- building hydraulic lift table
- learning to pre fit Aluminum
- learning how to make weld beads
- learning about etch primers, red oxide primers, RAL colours
- building paint booth
- learning how to airbrush & how to clean them
- fitting, prime/painting, building wheels and in what order to do that lol
Just finished the wheels this morning and I must say that was a lot of fun ...... and time.

I just wanted to acknowledge how helpful the Armortek forum has been. It has guided me threw all of my desisuins without bothering to many people with questions
I have been probably been threw everyone’s KT builds and and am so impressed by everyone’s levels of dedication and time spent on these projects.

Here are some pics of my progression so far

Nice work Brent looking good! I like the paint booth paint job!
Best regards,
Bob

Progress pics

A lot of good work already achieved, These are a big project, looking good Brent, regards simon manning.