Page 1 of 1
Help please
Posted: Wed Nov 06, 2019 10:33 am
by Vince Cutajar
As one can see from the above photo, the barrel of the Tiger 1 has a locking ring with slots cut in the ring for a large C spanner. Could somebody advise me if there are two or three slots in this barrel locking ring?
Thanks in advance.
Vince
Re: Help please
Posted: Wed Nov 06, 2019 10:46 am
by mark lawson
Morning Vince, there are x3 of these grooves around the gun barrel one is facing upwards directly in the middle of the gun.
Re: Help please
Posted: Wed Nov 06, 2019 1:43 pm
by Ivano Costantini
Very interesting Mark, I've always seen two "notches" do you have photos in which you see that they are three?
Thanks Ivano
Re: Help please
Posted: Wed Nov 06, 2019 2:47 pm
by mark lawson
Not sure if I still have any pictures but will have a look over the next few days
Re: Help please
Posted: Wed Nov 06, 2019 3:02 pm
by Ivano Costantini
I checked,
i confirm that there are two "notches", at least in this tank,
can be seen clearly in this photo. However, you can also see clearly on 131.
Re: Help please
Posted: Wed Nov 06, 2019 3:03 pm
by Ivano Costantini
Photo
Re: Help please
Posted: Wed Nov 06, 2019 3:07 pm
by Ivano Costantini
Sorry but I can't publish the photo
Re: Help please
Posted: Wed Nov 06, 2019 3:15 pm
by Ivano Costantini
If you are interested, I published the photo on my Facebook profile. " Modellismo Omv "
Re: Help please
Posted: Wed Nov 06, 2019 3:30 pm
by Kent Wiik
Hi Vince,
Sorry for this late reply and yes it was 2 slots on this barrel ring.
On the Vimoutiers Tiger they was at 4 and 10 o’clock.
Kind regards
Kent
Re: Help please
Posted: Wed Nov 06, 2019 9:27 pm
by Vince Cutajar
Thank you Mark, Ivano and Kent for your assistance. It is very much appreciated.
Vince