Armortek

hi all

Anybody by chance have a picture of how to wire connect the MG flash cables to a Benedini Mini.

there are 2 wires Plus & Minus to the MG LED - how does these 2 connect to the output 1+2 on the benedini mini

Would it be Minus at the buttom and the Plus on top leaving the middle pin free or?

http://benedini.de/TBSMini_13_E.pdf

If it has been configured, it should be between the middle and top pins of "OUT 1+2",with the middle going to the anode (+ve) and the top going to the cathode (-ve).

Middle and bottom of "OUT 1+2" should be the trigger signal for the main gun recoil.

Adrian.

Thanks (again) Adrian