The Official Armortek Forum - World leader in one sixth scale metal kits

Posted: **Sun Aug 10, 2008 3:41 pm**

I am having a struggle to get the barrel unit to slide comfortably on the gun cradle.
The fit is very tight and I was wondering if there was a graphite type grease that would help the units to bed in together nicely without having to resort to files and things?

Regards Stewart.

Posted: **Sun Aug 10, 2008 7:19 pm**

362 Valve Grinding Paste Coarse 500 Grit

I wonder if this would work?

Regards Stewart.

Posted: **Sun Aug 10, 2008 7:32 pm**

Hilfe,bitte!!!!

Anyone?

Regards Stewart.

Posted: **Sun Aug 10, 2008 7:48 pm**

Hi Stuart, not to sure about the grinding paste, make sure, the assembly is square, I used a fine flat file from a set of needle files to remove any burs along the edges, as the slide is quite long, the fit does not need to be tight
regards
Jeff

Posted: **Sun Aug 10, 2008 7:54 pm**

Hi Jeff,

Everything is square and I have filed all the burs in the grooves but still a tad to tight.

A little grind should sort it.

Take care

Regards Stewart.

The Official Armortek Forum - World leader in one sixth scale metal kits

Is there a grease that helps to wear down metal?

Is there a grease that helps to wear down metal?