Hi All,
The first of the Rolls parts is the Enots Oiler fitting, I'll be making the Oiler to go with it soon.
I would like to thank Pierce for all the suggestions and reference material he is providing for the Rolls.........and also the eye strain Sanding a .75mm ball and drilling into the end of a 1.5mm plastic rod to fit i!................I think I'll retire to a cold cider now.
Best regards
Dave
Enots Oiler Fitting
-
- Posts: 1154
- Joined: Thu Jul 12, 2007 6:03 pm
- Location: Hampshire
- Has liked: 115 times
- Been liked: 1100 times
- Contact:
Enots Oiler Fitting
www.armorpax.net
There used to be a nice banner here till Photobucket lost everything.............................
There used to be a nice banner here till Photobucket lost everything.............................
-
- Posts: 1154
- Joined: Thu Jul 12, 2007 6:03 pm
- Location: Hampshire
- Has liked: 115 times
- Been liked: 1100 times
- Contact:
Re: Enots Oiler Fitting
Hi All,
First test piece of the Enots fitting. We will be adding packs of these to the range soon.
Best regards
Dave
First test piece of the Enots fitting. We will be adding packs of these to the range soon.
Best regards
Dave
www.armorpax.net
There used to be a nice banner here till Photobucket lost everything.............................
There used to be a nice banner here till Photobucket lost everything.............................
Re: Enots Oiler Fitting
Does anyone on the forum know where the Enot oilers go? As Dave Dibbs was kind enough to make them as detailing parts for the Rolls Royce it seems a good idea to actually fit them!
-
- Posts: 579
- Joined: Mon Oct 09, 2017 9:49 pm
- Has liked: 96 times
- Been liked: 438 times
Re: Enots Oiler Fitting
Hi Phil:
Got your messages and, yes, I have an oiler chart I can send you and a chassis I'll photograph to show you the oiler points.
Cheers,
RPR
Got your messages and, yes, I have an oiler chart I can send you and a chassis I'll photograph to show you the oiler points.
Cheers,
RPR