The Official Armortek Forum - World leader in one sixth scale metal kits

Back at the bench with my 25pdr and trying to identify two small items on the Armorpax upgrade set.
I'm having a mare uploading a photo so I'll try and describe them. They are two tear shaped base plates with what can best be described as an egg cup and it's very shallow friend attached. I can't find them on any image I've discovered yet and hope someone here can help.
Cheers, Phil

Is that it Phil?

That's the big one, Phil. Any idea where the little one lives?

Best take a look on Daves build thread of the 25 pounder, I can't place it, you may have a spare there , I would need to see a photo, what's the problem with your photo uploading, does it say that the file is to big??.........Regards Phil.

A combination of rushing and poor memory was responsible for the photo failure. I'll get it sorted on the morrow. I'll check Dave's post again and see if I can spot it. Thanks for your help.

Hi Phil,

If the back plate is identical on both it may be a miss form on the primary casting. If I get an air bubble and it does not fully form the handle rather than throw the whole plate away I do a secondary cast to redo that part. Once I see the pics will be able to confirm.

Best regards

Dave

Think I've done it. It's 'B' that's causing concern. Or it may be a bubble!

Hi Phil,

B didn't form properly when I cast the plate with the travel lock etc on it so I have added a fully formed one. You can throw B away and A is the handle for the site guard plate shown by Phil earlier in the thread.

Best regards

Dave

The new phenomenon "URO's" nice one Phil, regards Phil.