The Official Armortek Forum - World leader in one sixth scale metal kits

Where did everyone put weld marks? Is there any good pic's of anyone's tank with the welds?

Hello Michael ... What I did was to buy one of Dragons new 2007-2008

1/35 scale tiger kits . They have all the correct welds in the right places . Plus it is handy as a builders model.

you guys are a wealth of information..thanks!

michael didonato wrote:you guys are a wealth of information..thanks!

I sense sarcasm.

Michael, look at all of Dale's posts regarding his Tiger build. great weld reference. As I have not built my Tiger yet, I didn't feel qualified to respond when you first posted but read with interest for future reference.

As far as views to response ratio? get used to it. As Adrian said, It's a forum open to public viewing.

kind regards

Tim

Micheal Relax !! What more info could you have wanted ? Dale has given you a good answer to your question?
I've taken Dale's advise on board and ordered the kit for future reference when I recieve my Tiger , Cheers for that Dale !!

Sean

michael didonato wrote:you guys are a wealth of information..thanks!

There were two good reference book that a few of us gotten during the introduction of the armortek tiger, it shows all the patterns of the welds. I need to dig for the book and provide you with the name and publisher.

Meanwhile, can some one recall?

Hi Michael,

Just managed to dig this out over the weekend....when I found the time Most if not all the old timers working on their Mid to Early Tigers recommended this book as one of the most informative among the two, IMO. There is a wealth of information comparing the different versions. Lots of drawings, pics and details. More than enough for your questions on weld marks.

The reference book: The Modeler's Guide to the Tiger Tank - A complete and comprehensive guide to modeling the Tiger I and Tiger II in 1/35 scale

Publisher: Ampersand Publishing