Page 1 of 1

Belly access plates

Posted: Thu Feb 16, 2017 11:19 pm
by Steve Norris
With the imminent release of the Panther A, i am in the process of gathering parts for my build.
I would like a set of belly access plates but do not have access to a lathe, can anyone suggest where I can get these items made or be willing to make these for me at a reasonable cost.
Regards
Steve

Re: Belly access plates

Posted: Thu Feb 16, 2017 11:48 pm
by mark lawson
Steve are you wanting all x10 making

Re: Belly access plates

Posted: Fri Feb 17, 2017 8:11 am
by Stephen White
Steve

I've got the kit to make them. Would you like to pm me with what you had in mind? I haven't got any Panther refs so I'd need the drawings. Loved your previous Panther build blog.

Stephen

Re: Belly access plates

Posted: Fri Feb 17, 2017 12:30 pm
by mark lawson
Steve, the x2 Largest plates are 75mm

Re: Belly access plates

Posted: Fri Feb 17, 2017 5:50 pm
by Stephen White
Thanks Mark. A bit too big for my lathe but could be done on the rotary table. The others are OK for turning. All the best.
Stephen

Re: Belly access plates

Posted: Sat Feb 25, 2017 4:32 pm
by Phil Markham
Steve, Mark, Stephen,

I have a Panther A on order and am also gathering parts. I would also be very interested in any parts produced if your thinking of running a set off and the price was good. I don't have access to a milling machine or lathe so this would be very useful and may make more worth your time and effort in doing it if you have more than one buyer. :wink:

Phil