Morris Quad C8
Posted: Thu Nov 10, 2016 2:30 pm
Hi all
Just a few photos of Quad 036 progress
Just a few photos of Quad 036 progress
I take it from the base coat that you're going for a Western Desert paint scheme
Adrian.
Page 1 of 1
Re: Morris Quad C8
Posted: Tue Nov 15, 2016 8:40 pm
Looking good so far
I take it from the base coat that you're going for a Western Desert paint scheme
Adrian.
I take it from the base coat that you're going for a Western Desert paint scheme
Adrian.
Re: Morris Quad C8
Posted: Tue Nov 15, 2016 8:47 pm
Looks good Rick.
Re: Morris Quad C8
Posted: Wed Nov 16, 2016 4:39 pm
Hello Rick, nice work, may I check with you.....in your photographs part number EMO609 (which supports the two winch rollers, parts number EMO610) looks to be facing to the rear of the Quad.....on my build EMO609 is on the other side of the rear beam and facing towards the front of the Quad. I may be wrong, so I apologise if I have made the mistake. 
...Mick
...MickRe: Morris Quad C8
Posted: Wed Nov 16, 2016 6:11 pm
Well spotted Mick.
This picture shows the relative position of the pulleys.
Adrian.
This picture shows the relative position of the pulleys.
- "Combat Cars" Restoration
Re: Morris Quad C8
Posted: Sun May 13, 2018 9:01 pm
Met up with Ricky's Quad and 25 Pounder at the UKTC BBQ in Reading yesterday.
I think it's fair to say it's come along a bit since these pictures were taken.
Now features a fully tricked out engine bay and engine, including a working starting handle !!
The gun and the limber are getting the same sort of treatment as well.
Adrian.
I think it's fair to say it's come along a bit since these pictures were taken.
Now features a fully tricked out engine bay and engine, including a working starting handle !!
The gun and the limber are getting the same sort of treatment as well.
Adrian.