Armortek

UPS delivered Quad number 11 here on Thursday, so I have decanted it into my normal plastic storage crates and have gone through the parts list.

It seems to me that there are more parts in this Quad than there in a tank assuming you ignore all the track links

Adrian.

A couple of thoughts re the build process.

I wouldn't install the foot well pieces (EM0321) until after the engine bay has been attached, as they cover two of the mounting bolts for the engine bay sides.

Also, the front mudguard struts (EM0328) fit with the dog leg facing forward and down.

Other than that it's gone together a treat so far.

Adrian.

I had some fun with the spare wheel over the weekend.
I used a countersink bit to open up the extraneous holes, then filled them using some Durafix aluminium welding rod.

Once the wheel had cooled down I transferred it to the CNC lathe and skimmed the excess material off the face. I also skimmed it flat to the rim, as I plan on adding two disks to the front and rear wheels, to simulate their different orientation.

Next operation was to move the wheel to my new rotary table and drill out the six additional mounting holes, using the two original ones as guides.

I have to admit that, having passed the half century this year, it appears I still can't count up to 11.25 six times...

So, having repeated the filling and skimming phases, the drilling went to plan on the second attempt

Quite a bit of work just to remove two holes, but fun none the less, and an easy introduction to using the rotary table.

Adrian.

Hi Adrian,

As pm, please see the below photos, I hope these help.

Regards

Dave

Hi Adrian,

I hope you don't mind me asking a question with regards your Quad build. I have put the front axel together and wondered if you had an issue with the half shafts. I have assembled the axel many times with the same result with what seem to be half shafts that are too long. Have you come across this or is it just me and if you have, how did you managed to overcome the problem?

Regards

Dave

Dave,

Have you read ALL the posts on the Quad forum because you might find the answer in there.

Dennis.

Dave

if you look at the posting by Ken Walter (front axle) dated 28/02/2017 the probable answer is there in the answers to his enquiry for you to see

Thanks guys for the advice and I had read the topic re "front axle" to which I have added how I fixed the problem.

Regards

Dave