The Official Armortek Forum - World leader in one sixth scale metal kits

Hell, I'm new to the Armortek world and in advance of my Tiger 131 kit being delivered I'd like to have ready a reasonable representation of the early engine the HL210 ready to install.
I have found some drawings and photos and am fairly confident it's not beyond me but to start with I need to know some crucial dimensions to scale the motor accurately to 1:6.
1) The overall height from the base of the dry sump to the top of the middle aircleaner.
2) The PCD of the mounting bolts at the front of the unit.
3) The length of the block from the mounting flange at the front to the flywheel at the rear.
If anyone has a fully dimensioned drawing that'd be a great help
CAD intrigues me and I'm considering a 3d printed version also.
Thanks.
John Snook

Hello John,

I only found a drawing from the HL-230, but as far as I know the basic-motor
is the same, only the add-on assemblies are different, and some differences
like cylinder-capacity an alu-cylinder head.
http://s3.postimg.org/a9t3ybwsj/hl230p30.jpg

Christian,
Many thanks - just the information I need
I think it'll be a while before I start my build though,
Cheers

In case you were unaware I offer a full detailed resin kit of the HL210 engine, and the other HL210 engine compartment fittings,

http://eastcoastarmory.com/tiger.htm