Page 1 of 1
Mezzanine Floor and first new CNC Machine,
Posted: Fri Apr 25, 2014 1:20 pm
by Armortek
Our mezzanine floor is now in and we are beginning the process of sorting all the stock and moving it upstairs.
The first of our two new CNC machines arrived today.
This 5 axis machine will allow us to machine multiple faces of each part in one setting, further improving accuracy and allowing more detailed parts to be produced.
More photos:
https://www.facebook.com/media/set/?set ... 791&type=1
Re: Mezzanine Floor and first new CNC Machine,
Posted: Fri Apr 25, 2014 1:53 pm
by Maarten Schutjes
Congratulations. An impressive tool by the looks of it...
Re: Mezzanine Floor and first new CNC Machine,
Posted: Fri Apr 25, 2014 1:57 pm
by John Fitzsimons
Alll very impressive and looking forward to seeing even more improvements to products.
Re: Mezzanine Floor and first new CNC Machine,
Posted: Fri Apr 25, 2014 2:48 pm
by Steve Norris
Looks like a excellent addition to the machine shop. The MK IV also seems to have impressive load carrying ability .
Regards
Steve
Re: Mezzanine Floor and first new CNC Machine,
Posted: Fri Apr 25, 2014 4:17 pm
by Paul Morris
All looking very smart
Well done cheers Paul.
Re: Mezzanine Floor and first new CNC Machine,
Posted: Fri Apr 25, 2014 4:22 pm
by Derek Attree
Hi Gill and Mark
Looking good with all the stock upstairs will keep you fit running up and down.
Nice machine I see you have gone away from Hass any reason for that ?
Regards
Derek
Re: Mezzanine Floor and first new CNC Machine,
Posted: Fri Apr 25, 2014 4:32 pm
by Armortek
The last turning machine we bought was also a Doosan, and the service from the agents has been first class. These machines are also more heavily constructed and therefore more accurate and productive.
Re: Mezzanine Floor and first new CNC Machine,
Posted: Fri Apr 25, 2014 6:16 pm
by Martin Diessel
Hi Gill, Mark your new layout looks sharp and highly professionel! Wisch I had some of such stock! Keep on! Martin
Re: Mezzanine Floor and first new CNC Machine,
Posted: Fri Apr 25, 2014 7:19 pm
by leesellars
Time for the Open day to be back at the factory then.
Lee
Re: Mezzanine Floor and first new CNC Machine,
Posted: Sat Apr 26, 2014 9:39 am
by Bob Farmer
So when and what is the next release? How about a re- release of the Tiger or KT?