Armortek

hi guys
i know i have posted a topic below this about the same probelm, but this problem has only started since installing the Benedini and swapping to a Futaba super 9.
I'm getting movement on the elevation (down) and turrent turn (left) when powering up.
Does anyone think this is the electroneze auto switcher problem? or a Futaba problem?
Would appreciate any help whatsoever.
Richie

Hello Richie

It sounds like a Futaba Problem. I think what is happening is when the transmiter and reciver are communicateing for the first time its going to its defaut settings. What is its saying about it in the futaba manual.?

Lee

Hi Lee
Thanks for reply. its not everything, it is just the two that's on the electroneze auto switchers that doing the movement on start up. I have three other servos working different things and they are all fine. looking in the Futaba mannual (which is as thick as the yellow pages), I can't seem to find anything.
I was advised to put it on acrobatics by Futaba, as the other settings were for helicopters and planes.
Thanks for your help.
Richie