The Official Armortek Forum - World leader in one sixth scale metal kits

Ok Another Question.

The Square Stand Off's that hold the side guards on, are they just held on with loctite?

Hi Steven,
Yes a strong retainer or strong glue.
I used a strong retainer like that used for slip fit parts.
I was still able to pinch the screws up nicely without breaking the seal.
Cheers
Phil

I used Araldite Rapid and could wind the nuts down tight in an hour

Ok New Question

The front mud guards wont move when the pin are inserted. I tried filing both the inside and outside of the loop but still not enough room to move freely. Any ideas on what im doing wrong

G'day Steve, I had the same problem. I drilled the hinge holes out from 2mm to 2.5mm and used a m2.5 button head & nut.

http://www.armortek.co.uk/Forum3b/viewt ... 6&start=45

Works fine for me.

cheers
Ray

I used countersunk instead of hex bolt underneath for better clearence. Then it worked fine without drilling.

G'day again. I had trouble with the pins fitting. So I just drilled to save time & frustration.

Cheers
Ray