Armortek

When I display my P IV not all organosors allow you to run your model at the show and I am often asked will it "go" by vistors.
So I made this plate jack to lift the tracks off my hydraulic display table to allow them to turn without moving the tank forward/back.
Its about 24" long x 8" wide, just fits under the belly of the tank and lifts it approx 3/4".





It looks a bit rough because its made from whatever was to hand ie the base and side struts were from an old desk.

nice one Graham....I hope to take my Comet to our local 'shows',next year, this would be an ideal platform to display the tank on...thanks for the photo's...mick