Ampilier Module Connections

Provides official comments and advice from the Armortek design team
Post Reply
User avatar
Armortek
Site Admin
Posts: 2863
Joined: Tue Jul 10, 2007 10:30 am
Location: Winchester, England
Been liked: 3319 times

Ampilier Module Connections

Post by Armortek »

In our electronic module and amplifier module instructions we state that the sound unit control channel should be connected to channel 6 and that the blank firer should be connected to channel 5. Because of the way the new Futaba 7C radios are configured, it is much easier to reverse these two channels. The sound unit control should therefore be connected to channel 5, and the firing unit should be connected to channel 6. This will make allocating the three position switch much easier. (page 28 in the 7C manual)

Mark
Armortek

Post Reply