The Official Armortek Forum - World leader in one sixth scale metal kits

Hello,



In the munal they say you have to put 2 bearings nr 608 zz into the part CHO 484

But part nr CHO 483 has also the a diamter of a 608 zz bearing so i already glued 2 bearings in part nr CHO 484



My question is now how can i get one bearing out of part nr CHO 484 ( i try already with heat ) but i cant re-trackt the bearing.

Best regards Yves

Hello,

My mistake i find out now that there are 2 diferent pivot bolts.
Problem solved.

Best regards Yves

Hi Yves
If this is for the jagdpanther kit look at Chris's build the
bracket has been changed in the recoil pack to whats shown in the main manual. Assuming you are getting all the Motion packs .

Regards Derek

Hello Derek,

I found already the other longer pivot bolt.
Thanks

Working on the gun now.

Best regards Yves