Re: Brian's 2017 NO. 10 Pre-Build
Posted: Fri May 11, 2018 1:36 pm
Interesting, thank you!Vince Cutajar wrote: ↑Fri May 11, 2018 12:37 pmAnd the tools being used are on the previous page.
Vince
Page 2 of 2
Re: Brian's 2017 NO. 10 Pre-Build
Posted: Mon May 14, 2018 3:41 am
This is why i am going to model my mid production Tiger after one of the few early ones without zimmerit. It is so hard to get right. I just think it does not scale well. But then again I hate the look of it on photos of real Tigers as well. It ruins the clean lines.
A few people seem to have the, ability to do it well, I know I would get tired of looking at it.
A few people seem to have the, ability to do it well, I know I would get tired of looking at it.
Re: Brian's 2017 NO. 10 Pre-Build
Posted: Mon May 21, 2018 1:05 am
Hey Greg, I know how you feel! I have no choice except to embrace the zim. Honestly it grows on you though.
Greg Stephens wrote: ↑Mon May 14, 2018 3:41 amThis is why i am going to model my mid production Tiger after one of the few early ones without zimmerit. It is so hard to get right. I just think it does not scale well. But then again I hate the look of it on photos of real Tigers as well. It ruins the clean lines.
A few people seem to have the, ability to do it well, I know I would get tired of looking at it.
Re: Brian's 2017 NO. 10 Pre-Build
Posted: Mon May 21, 2018 1:07 am
tools and joint compound test look good
Re: Brian's 2017 NO. 10 Pre-Build
Posted: Mon May 21, 2018 1:57 am
I think I found some nice paint.
Re: Brian's 2017 NO. 10 Pre-Build
Posted: Mon May 21, 2018 4:32 pm
The zimmeritt is looking good. It was also suggested to me to add PVA glue to the jointing adhesive.
Vince
Vince