Armortek

Driving the Comet off the table lift...

Ground level....heart rate back to normal...

Now on hardstanding....new home...

Like it....

Table lift now in my workroom....1130hrs

Furniture back in place, cleaner run around, tidy tidy....my good lady will never know.
I think I have time to treat myself to lunch...Morrisons Supermarket....double egg and chips...

> ...my good lady will never know.

Until she tries to sit at the table

Adrian.

Hi Mick
Very nice bit of Covert Reorganisation.
I dont think your good lady will notice the Comet under
her favourite dress
Your Panther is coming together real nice,plenty of parts
to enjoy.
Regards
Phil

i like it michael, i would have one of mine in the house if i could get away with it,regards simon manning.

HI MICK
Glad your all sorted ,i think you need to change the comoflage on the comet its not quit blending in with its surrondings .
best wishes ,,,,,,,,,,,,,,,nick

Hello Guys, thanks for your replies.....would you believe....she still has not noticed the changeover.....
To be fair...she will. I have a well rehearsed answer.....and..... I did the hoovering/cleaning.
You do not get to my age without knowing most of the answers, to most of the questions.....Mick

Hello everyone, started on the tyre fitting.....I have gone for the system I used on my Comet. Because the tank will not be used in anger, gentle run around, no hard driving. I applied M3 super strength double sided tape to the wheel. The rubber tyre is then carefully pressed onto the rim. Lovely clean finish....Mick

hi michael, does this tyre fixing meathod work, as i rarely drive my tanks the glue process seems extreme to me and messy, regards simon manning

Hello Simon, yes I used this method to great effect on my Comet....I asked for advice on the Forum during the Comet build. Most prefer the Loctite adhesive, however, I have had a bad experience with Cyanoacrylate glues.
I would say that M3 super strength double sided tape is cleaner,quicker,and unless you drive your tank to the limit, the best option. I know others have used this method with success....Mick

This is my method